18
Adaptor in Place for
Outside Top Exhaust
C. OUTSIDE TOP EXHAUST (VERTICAL DUCT)
A. RECIRCULATING (Non-Vented Ductless)
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Check Blower Plate
A4. Mount the Microwave Oven
A5. Install or change Charcoal Filter
IMPORTANT NOTES:
• Make sure the screws for the blower motor and blower plate are securely tightened when
they are reinstalled.
This will help to prevent excessive vibration.
• Make sure the motor wiring has been prop
erly routed and secured, and that the wires are
not pinched.
NOTE: Read the pages 14-15 only if you plan to vent your exhaust to the outside.
If you plan to recirculate the air back into the room, proceed to page 10.
See page 20
3/8" TO EDGE
NOTE: IT IS VERY IMPORTA
NT TO
READ AND FOLLOW THE D
IRECTIONS
IN THE INSTALLATION INSTR
UCTIONS
BEFORE PROCEEDING WITH
THIS
REAR WALL TEMPLATE.
This Rear Wall Template serves
to position the bottom
mounting plate and to locate the
horizontal exhaust
outlet.
1. Use a level to check that the t
emplate is positioned
accurately.
2. Locate and mark at least one
stud on the left or
right side of the centerline.
It is important to use at least one
wood
screw mounted firmly in a stud to
support the weight
of the microwave. Mark two add
itional, evenly spaced
locations for the supplied toggle
bolts.
3. Drill holes in the marked locat
ions. Where there is
a stud, drill a 3/16" hole for w
ood screws. For holes
that do not line up with a stud
, drill 5/8" holes for
toggle bolts.
DO NOT INSTALL THE MOUNT
ING PLATE
AT THIS TIME.
4. Remove the template from the
rear wall.
5. Revie h
t
w e Installation Instruction boo
k for your
installation situation.
Locate and mark holes to alig
n with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STU
D ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR
2 ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN
THE MOUNTING PLATE
AREA.
Locate and mark holes to alig
n with holes in the
.
e
t
a
l
p
g
n
it
n
u
o
m
IMPORTANT:
LOCATE AT LEAST ONE ST
UD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR
2 ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN
THE MOUNTING PLATE
AREA.
Trim the rear wall template a
long the dotted line.
Trim the rear wall template a
long the dotted line.
12"
4"
Darle vuelta a la hoja para cons
ultar la
versión en Español.
