Midea TC051K6BW-S, Инструкция по эксплуатации, Страница: 15 / 50

15
Draw a vertical line on the wall at the center of the 30″ space.
Tape the Rear Wall Template onto the wall matching the centerline
and touching the bottom cabinet frame.
to Cooktop
C
3/8" TO EDGE





 

 





NOTE: IT IS VER
Y IMPORTANT T
O
READ AND FOL
LOW THE DIRE
CTIONS
IN THE INSTAL
LATION INSTRU
CTIONS
BEFORE PROC
EEDING WITH T
HIS
REAR WALL TE
MPLATE.
This Rear Wall Tem
plate serves to posi
tion the bottom
mounting plate and
to locate the horiz
ontal exhaust
outlet.
1. Use a level to ch
eck that the templa
te is positioned
accurately.
2. Locate and mark
at least one stud o
n the left or
right side of the c
enterline.

It is important to us
e at least one woo
d
screw mounted firm
ly in a stud to supp
ort the weight
of the microwave. M
ark two additional,
evenly spaced
locations for the su
pplied toggle bolts. 3. Drill holes in the
marked locations.
Where there is
a stud, drill a 3/1
6" hole for wood scr
ews. For holes
that do not line u
p with a stud, drill 5
/8" holes for
toggle bolts.

DO NOT INSTALL
THE MOUNTING
PLATE
AT THIS TIME.
4. Remove the tem
plate from the rear
wall.
5. Review the Insta
llation Instruction b
ook for your
installation situa
tion.
Locate and mark
holes to align w
ith holes in the
mounting plate.
IMPORTANT:
LOCATE AT LE
AST ONE STUD
ON EITHER SID
E OF
THE CENTERLIN
E. MARK THE LOC
ATION FOR 2 A
DDITIONAL, EVE
NLY
SPACED TOGG
LE BOLTS IN TH
E MOUNTING P
LATE
AREA.
Locate and mark
holes to align with
holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEA
ST ONE STUD O
N EITHER SIDE
OF
THE CENTERLIN
E. MARK THE LOC
ATION FOR 2 A
DDITIONAL, EV
ENLY
SPACED TOGG
LE BOLTS IN TH
E MOUNTING P
LATE
AREA.
Trim the rear wa
ll template along
the dotted line.
Trim the rear wa
ll template along
the dotted line.











12"
4"
Darle vuelta a la h
oja para consultar
la
versión en Españo
l.
30
1/4"
Minimum
clearance
Plate position-beneath framed recessed cabinet bottom
Your cabinets may have decorative trim that interferes with the microwave installation.
Remove the decorative trim to install the microwave properly and to make it level.
Use a level to make sure the cabinet bottom is level.
If the cabinets have a front overhang only, with no back or side frame, install the mounting
plate down the same distance as the front overhang depth.
This will keep the microwave level.
1. Measure the inside depth of the front overhang.
2. Draw a horizontal line on the back wall an equal distance below the cabinet bottom as
the inside depth of the front overhang.
3. For this type of installation with front overhang only, align the mounting tabs with this
horizontal line, not touching the cabinet bottom as described in Step D.
THE MICROWAVE MUST BE LEVEL.