INSTALLATION AND OPERATION MANUAL, GAS KETTLE, MODEL GL-30
10156R2
8
2012-11-28
2.0 INSTALLATION
(Continued)
WARNING: For an appliance equipped with casters, the installation
shall be made with a connector that complies with the standard for
connectors for moveable gas appliances, ANSI Z21.69-CSA 6.16
and a quick-disconnect device that complies with the standard
for quick-disconnect devices for use with gas fuel, ANSI Z21.41-
CSA 6.9; adequate means must be provided to limit the movement
of the appliance without depending on the connector and the quick
disconnect device or its associated piping to limit the appliance
movement; the location where the restraining means may be
attached to the appliance is on bottom of unit directly below relief
valve.
If the unit is also equipped with an optional water fill valve it too
must be installed with a flexible water supply tube, a quick
disconnect and strain relief.
WARNING: Do not connect the appliance to the electrical supply
until after the gas connection has been made.
1.
120 VAC - 60 Hz - Single Phase.
Units with this electrical rating are factory supplied with a three-wire cord and three-prong
plug which fits any standard 120V, three-prong grounded receptacle. A separate 15 amp
supply is needed for each unit.
WARNING: ELECTRICAL GROUNDING INSTRUCTIONS
This appliance is equipped with a three-prong (grounding) plug for
your protection against shock hazard and should be plugged
directly into a properly grounded three-prong receptacle. Do not cut
or remove the grounding prong from this plug. (120V units only).
