Microwave Data Systems iNET 900 Series, Руководство пользователя

Страница: 29 / 180

MDS 05-2806A01, Rev. E.1 MDS iNET 900 Series User’s Guide 21
2.5 STEP 4—REVIEW TRANSCEIVER
CONFIGURATION
2.5.1 Getting Started
Start by logging into the Access Point. Set up the Access Point first
because the Remotes are dependent on its beacon signal to achieve the
“associated” state.
NOTE:
Transceivers are shipped from the factory set to the “Remote”
mode unless they are marked differently.
Once the Access Point is up and running, move the computer connection
to each of the Remote units, log-in at each unit, review their configura-
tion, set their IP addresses and Network Name and wait for each to
achieve the associated state.
With all units associated, you will be ready to connect and test your data
services.
2.5.2 Procedure
The following is a summary of the configuration procedure that must be
done on each unit in the system. Key parameters are shown on the
Embedded Management System overview (
Figure 3-1 on Page 28) . A
lists of parameters can found in two tables: Table 4-5 on Page 119 and
Table 4-7 on Page 122 . Detailed information on using the Management
System can be found in MS INTRODUCTION on Page 27 .
NOTE:
The Management System supports the use of “configuration
files” to aid in uniformly configuring multiple units. These are
detailed in
Using Configuration Scripts on Page 98 .
2.5.3 Basic Configuration Defaults
Table 2-1 provides a selection of key operating parameters, their range,
and default values. All of these are accessible through a terminal emu-
lator connected to the
COM1 serial port or through a Web browser con-
nected to the
LAN
Port. (See Figure 5-1 on Page 129 for hookup.)
NOTE: Access to the transceiver’s Management System and changes
to some parameters, are controlled by password when
accessing by means of a Web browser or Telnet.