Microtronics 305001, Руководство пользователя

Страница: 104 / 127

5. Enter the values that you have determined for the zero point adjustment ("Trim offset") and
the installation height of the sensor ("Sensor offset") and click on the "Save" button. You can
also use the ">0<" button to use the current value of the "Raw" field as the "Trim offset". An
example for determining the "Trim offset" and the "Sensor offset" is provided in "Additional
explanation on the zero point adjustment and installation height of the sensor" in chapter
"Measurement channels" on page 67.
Note:
"Value" = "Raw" + "Trim offset" + "Sensor offset"
"Offset" tab
1 Raw: Measurement value of the universal input in the measurement unit without trim off-
set and sensor offset, i.e. the value corresponds to the output value of the scale module
(see "Internal processing of the measurement values" on page 29)
2 Trim offset: Provided to adjust the zero point (see "Additional explanation on the zero
point adjustment and installation height of the sensor" on page 70). Corresponds to the
"Trim" parameter of the "Basic" tab in the "Measurement channels" configuration sec-
tion (see "Measurement channels" on page 67)
3 Value: Measurement value of the universal input in the measurement unit including trim
offset and sensor offset, i.e. the value corresponds to the output value of the trim/sensor
offset module (see "Internal processing of the measurement values" on page 29)
4 Trimmed: Measurement value of the universal input in the measurement unit including
trim offset
5 ">0<" button for the automatic zero point adjustment. This means that the "Raw" field is
used as the "Trim offset", whereby the prefix is changed. When pressing the button, the
"Trim offset" and the "Sensor offset" are transferred to the device and saved.
6 Sensor offset: Specifies the installation height of the sensor (see "Additional explanation
on the zero point adjustment and installation height of the sensor" on page 70). Cor-
responds to the "Sensor offset" parameter of the "Basic" tab in the "Measurement chan-
nels" configuration section (see "Measurement channels" on page 67)
104 Rev. 02