Quick Start Guide 3
miriac SBC-S32V User Manual
V 1.1
9/81
© MicroSys Electronics GmbH 2017
3
Quick Start Guide
3.1
Prerequisites
Always make sure to handle the SBC-S32V unit ESD-
safe! Otherwise, the unit may suffer permanent damage.
However, do not place the unit directly flat on a metal
surface, as this may result in short circuits and damage
to the board.
At first time operation unpack the unit and make sure that is clean and free of visible
damage or foreign objects.
3.1.1 Minimum Requirements
To operate the board, you will at least need the following items:
■
an adequate power supply, delivering 12V DC (stabilized) / 2 A min.
■
an USB cable (type A
– micro B) adapted to connector USB
■
a serial terminal, such as a PC with an USB port running a terminal Software
(e.g. TeraTerm, HyperTerminal, putty, Kermit...), or else a hardware serial
console.
Choose the following parameters:
(a)
115200 Bd
(b)
8 Data bits
(c)
No parity
(d)
1 Stop Bit
3.1.2 Recommended Items
The following items are not absolutely necessary, but strongly recommended for
practical operation and development purposes:
■
Network connection via LAN port (RJ45) to your local network installation
■
TFTP server available for downloading within the network
(Hint: may run on the same PC as the serial Terminal)
■
SD card as mass storage and/or boot media
