MPX-Module 6
miriac SBC-S32V User Manual
V 1.1
43/81
© MicroSys Electronics GmbH 2017
After the module has been pressed down, place the heatsink exactly over the
mounting holes without scratching or touching any other parts on the PCB.
Insert the outer screws first and tighten them just a few turns. Then insert the two
inner screws also with a few turns. Now check the gap between carrier and module
for other parts than the CPU touching the heatsink. Check the thermal CPU pad for
correct position. Tighten the four screws with no more than 30Ncm.
For the removal of the module, first unplug all connections to the system. Take off
the inner screws, then the outer ones. The thermal pad may cause the heatsink
sticking to the module, so take care, while pulling apart to avoid collisions with any
part of the module. Lift the module to about 25°and remove it from the connector.
Store the parts on a static free area.
