MicroPower STC Series, Руководство пользователя

Страница: 7 / 78

En
glis
h
7
Installation
Only an authorised installation engineer may carry out the installation.
The battery charger should be installed indoors in a space with a vapour barrier.
Locate the battery charger so that there is free circulation of air through the battery
charger’s ventilating openings.
Install the battery charger so that the gasses from the charging do not get sucked in
by the charger's fans.
Battery chargers for wall mounting are installed with hole-making as per illustration
(figure 1).
The battery charger is produced in different mains voltage variations. Check that the
power supply at the site of the installation complies with the rate voltage according to
the information on the battery charger’s rating plate.
The recommended mains fuse is specified on the battery charger’s rating plate.
The battery charger is connected to the mains voltage via a cable with a plug to an
earthed wall socket.
Connect the battery charger as per illustration (figure 2-3). Carefully check the
marking on the battery charger’s terminal blocks.
The red cable is connected to the battery’s positive pole and the black or blue cable
is connected to the battery’s negative pole.
Operation
Cable connections and control panel
All STC chargers (see figure 4)
1. Control panel
4. Switch
2. Mains cable with adapter 5. LEDs
3. Battery cable and charging glove
Charging
WARNING !
In the case of danger, disconnect the mains voltage by pulling out the plug from
the wall socket or by turning off the safety switch.
Connecting a battery
1. Check that the battery charger is turned off. The switch on the panel should be in
the 0-position.
2. Check the wiring and adapter to ensure that there is no visible damage.
3. Connect the battery to the battery charger.
4. Start the battery charger. Set the switch on the panel in the 1-position. The upper
LED lights and shines with a yellow light during the main charging phase. When