MicroPower STC Series, Руководство пользователя

Страница: 8 / 78

voltage has reached 2.43 V/cell, the battery charger goes over to additional char-
ging and the other yellow LED lights. The time for additional charging is approx.
60% of the main charging time.
5. A green LED is displayed when the battery is full charged. The battery goes over
to maintenance charging.
Note! The green LED will not light immediately if a fully charged battery is connected.
This time can vary between 0,5 and 1 hours.
Disconnecting a battery
1. Turn off the battery charger. Set the switch on the panel to the 0-position.
2. Disconnect the battery from the battery charger.
WARNING !
The battery charger should be turned off when disconnecting the battery.
If the battery is disconnected during an ongoing charge, the contacts in the
charging glove will be damaged and spark formation can occur causing a
hydrogen gas explosion
Maintenance
May only be performed by qualified personnel.
Safety shut-off
If battery voltage does not reach 2.43 v/cell after 10 hours charging, the battery char-
ger is turned off. The lower red LED lights indicating the safety shut-off.
Troubleshooting
May only be performed by qualified personnel.
Checks
1. Check that the battery is free from defects, in good condition and is the correct type
for the battery charger.
2. Check that the battery is correctly connected and that the battery fuse, if any, is
whole.
3. Check that the mains voltage is correct and that all fuses are whole.
4. Check the wiring and adapter to ensure that there is no visible damage.
Recycling
It should be possible to recycle the battery charger as metal and electronic scrap.
En
gl
ish
8