Microplex SOLID F44, Руководство пользователя

Страница: 78 / 167

Troubleshooting and Diagnostics
6-3
Display That means ... Measure
NO IC UNIT No Image Cartridge installed Insert a new Image Cartridge
INVALID IC Wrong Image Cartridge Install an IC from MICROPLEX
EXCHANGE IC
Image C artridge used
(life 180,000 pages)
Insert a new Image Cartridge
(see chapter 1.5)
EXCHANGE TRU
T
ransfer
R
oller
U
nit used
(life 150,000 pages)
Insert a new Transfer Roller
Unit (see chapter 5.3)
EXCHANGE FUSER Fuser used (life 500,000 pages)
Fuser can be replaced by the
service
NO PAPER No paper
Load paper into the tractor
and press [ONLINE]
STACKER FULL
Remove paper from the iPS
and press [ONLINE]
STACKER BUSY
The stacker is in the phase of the
initialization. The Paper Exit Tray
of the iPS is moving up and down
and stops at working position.
The printer does not start in this
time any print job.
wait
WRONG
PAGELENGTH
Warning!
If
PAPER LENGTH in the PAPER
MENU is set to a value less than
7 inch or greater than 17 inch the
WRONG PAGELENGTH
message is displayed.
If the paper length is less than 7
inch the movement of the
pendulum will be for a page
length of 7 inch, and greater than
17 inch a movement for a page
length of 17 inch.
See in Chapter 4.2.1 PAPER
MENU the parameter
LENGTH FACTOR
After pressing [ONLINE] the
printer continued the print job.
A correct stacking cannot be
guaranteed since the paper
length is exceeding the
operating range of the
stacker.
ST.PAPERGUIDE Paper guide cover of iPS open Close paper guide cover
STACKER ERROR
Error when reading the EEPROM
of the stacker. The stacker is
further operational but the
parameter setting after the last
power off has been lost.
In case of a malfunction of
the pendulum new paper
must be inserted again.
Error still there: call service.