_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX
Operator’s Manual logiJET T4-2 /T6-2 /RFID
Edition 2.2
10.4.3. Writing Data into a Data Block of the RFID Label
The IDOL command used in the following example enables you to write data
into the data blocks of the RFID label.
Example:
The text ”MICROPLEX“ is to be written into the user block of the RFID label.
Send the following command to the printer via the print data channel:
&%&%rf 11 01 99*MICROPLEX*
This command effects that the string “MICROPLEX“ is written into the RFID
chip (without write protection).
Note:
Data are given as a text string, the data format can be set by the
parameter k12 (binary = default, see section 10.4.1).
The length of the data is flexible. Therefore the end of data has to be
marked by a so-called termination character, which has to be located at
the end of the text string. The termination character can be chosen freely,
it has to be defined at the first position of the parameter k99. Important is
to make sure that this termination character does not exist within the bar
code data itself. In the example described above the character * is used
as termination character.
Note:
The command described above may reduce the print speed.
If the RFID tag is not programmable for any reason, the label will be
printed with an overstrike pattern, indicating that it should not be used.
(Compare section 10.6).
