_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX
Operator’s Manual logiJET T4-2 /T6-2 /RFID
Edition 2.2
10.2.3. Adjusting the Transponder Position (Tag Position)
The transponder position depends on the RFID label type in use.
The right distance value between the transponder and the start of the label
(detected gap position) has to be set.
A) Automatic transponder position measurement by printer:
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1
]
[Engine
]
[Printspeed ]
[RFID Menu
]
[RFID Mode ]
[Search Tag Pos ]
[Searching Tag ]
[Position: + 20 mm ]
Notes
Turn the printer OFF LINE with this key.
The ENTER key gives the user access to
the menu structure.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key until
[RFID Menu ] is displayed.
Press the NEXT or PREVIOUS key until
[Search Tag Pos ] is displayed.
This message is displayed during the
automatic search procedure.
The ascertained tag position is displayed
and saved temporarily.
Using the ENTER key this new value can
be saved as setup value.
After this decision turn the printer ONLINE
again: Press the ONLINE key longer than
2 seconds.
