MicronWings Balsa Craft Cub, Инструкции по сборке

Страница: 10 / 16

Glue in the hardwood piece with the magnet
attached. But check which way this needs to be
glued in. Remember the magnets need to
attract to close the door.
After allowing to dry well your hatch should fit
like this. You may choose to use some of the
scrap balsa from the kit to add some
strengthening to the inside surface of this hatch.
At this stage you may want to sand down the
corners of the parts you just glued on. They
will be easier to sand down now than after the
wings and tail-plane are attached.
Remember not to sand down the area where
the wings and tail-plane attach.
You are now ready to glue the tail-plane in
place. Ensure it is level.
The gear mounting board can be used to mount the receiver on the top side and the battery on
the bottom side. Place some hook and loop tape on either side of the board as shown below.