MicronWings Balsa Craft Cub, Инструкции по сборке

Страница: 9 / 16

Remove the piece of scrap balsa from the front
of the bottom plate.
Glue the bottom plate in place. We recommend
using a slow drying glue to allow time to work.
Also use model masking tape to hold the joints
firmly together.
Glue the tail skid in place as shown.
Glue the top plate in place. We recommend
using a slow drying glue to allow time to work.
Also use model masking tape to hold the joints
firmly together.
Carefully cut out the bottom cover with a fine
hobby knife. Glue the hardwood part on the
right in the image onto the cover. Allow the
two tongues to protrude. These are for locating
and securing the cover in place.
There are two corner marks on the cover to help you align the hardwood piece.
Glue in the magnet into the balsa cover and the other magnet into the hardwood part.
Smear some glue over both sides to help hold these in place.
After this unit has dried gently sand the edges of the cover bay and the cover itself to allow it to
fit easily.