MicronWings Balsa Craft Cub, Инструкции по сборке

Страница: 7 / 16

From above – the slot for the motor is slightly pointing to the
right. This is to give right thrust to the motor to counter the
torque of the motor which tend to turn the plane to the left.
Next glue in lace part “M” at the front.
Also slightly bend back this part at a small
angle.
Crease the airframes along the dotted lines.
Make sure you have the sides laid out on the
table as shown in the image so they both bend
inward.
Put one side on without glue first and check
that all the slots line up and that it all fits
together okay. Then apply glue to the body
former frame and glue one side on. Glue the
part that was pushed back slightly so it goes
between the windows. We suggest using
Aquadhere glue (White balsa glue) for this part
because it dries slower and gives you time to
work.
Then, glue in place the remaining body
formers as shown here. These body formers
should be angled back about 5 degrees
because the side of the fuselage will bend in to
meet the other side at the back. So you want
these body formers to go straight acros the
body when those two sides are brought
together.
Part: M
Bend back slightly