3
Micron® 100W Soldering Station
FEATURES
• Suitable for lead free soldering applications
• Variable temperature control via LCD touch screen
• Zero switching circuitry for spike suppression
• High idle stability
• Fast heat recovery
• Interchangeable handle
• Three channels for stored temperature presets
INTRODUCTION
Thank you for purchasing the Micron Lead-Free LCD touchscreen soldering station – the best solution
for your soldering equipment needs especially for lead free applications! We believe that you will be more
than satisfied with many features and the versatility of your new soldering station. Please carefully read the
instruction manual prior to operation to maximize the advantages of using your new soldering station.
WARNING: This appliance is not intended for use by children or infirm persons without
assistance or supervision if their physical, sensory or mental capabilities prevent them from
using it safely. Children should be supervised to ensure that they do not play with the appliance.
Failure to observe this safety regulation could result in a risk to life and limb. The
manufacturer or supplier shall not be liable for damage resulting from misuse of the unit or
unauthorized alterations.
Caution:
• Always place the soldering iron in its original holder when not being used.
• Keep the soldering tip and heating element away from the body, clothes and flammable material when
in operation.
• The soldering tip and the heating element remain hot for some time after being switched off. Ensure that
you do not touch the soldering tip and the heating element.
• For your health, do not inhale solder fumes.
• You must not undertake work on live parts. Only a technician is recommended to undertake repairs.
Use original replacement parts only.
KEY FUNCTIONS
HEATER/SENSOR FAILED DETECTION:
If the sensor circuit fails the display read “S--E” and will
automatically cut off the heater power. If the heater circuit fails the display will read “H--E” and will auto-
matically cut off the sensor power.
ISOLATED IRON HOLDER WITH TIP CLEANER:
Made from low abrasive brass shavings instead of
conventional sponges. This meets RoHS requirements and cleans better with no water necessary.
LOW VOLTAGE OUTPUT FOR SAFE OPERATION:
The power unit is isolated from the A.C. line by a
transformer and allows 32Vac to drive the heating element. The solder handle runs on 32 Volts for safety,
and with a 100W high power ceramic heater, you get a super-fast heat-up and quick temperature recov-
ery. The solder handle is attached with a heat resistant, non-burning, flexible 6-wire cord, the jacket for
which is made from a burn-proof silicone rubber material.
ESD SAFE AND SPIKE FREE CIRCUITRY:
The “Zero Voltage” electronic switching design protects
voltage and current sensitive components (CMOS devices, etc.) against damaging current and transient
voltage spikes commonly produced by less efficient, mechanically switched stations.
