Micron® 100W Soldering Station
After removing the tip, blow out any oxide dust that may have formed in the tip retaining area of the barrel.
Be careful to avoid getting this dust in your eyes. Replace the tip and screw back the knurled nut barrel
assembly using only firm hand pressure to tighten. Pliers should only be used to tighten the nut to avoid
burning your fingers, but care should be taken not to over-tighten as this could damage the element.
GENERAL CLEANING
The outer cover of the iron and station may be cleaned with a damp cloth using small amounts of liquid
detergent. Never submerse the unit in liquid or allow any liquid to enter the case of the station. Never use
any solvent to clean the case.
IMPORTANT SERVICE NOTE:
There are no user serviceable parts inside the unit. Do not open the unit. If the fuse blows, only replace
with an equivalent fuse. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure they do not play with the appliance.
If the iron or station should become faulty or, for some reason not operate normally, the system should
be returned to the service department of your authorized dealer or service agent, or a similarly qualified
person, in order to avoid a hazard.
SPECIFICATIONS
Model
T 2460A
Input
220 - 240 VAC ~ 50 Hz
Output
32 VAC / 100 W
Fuse (Fast type)
1A
Temperature Range
100°C - 500°C
Temperature correction Range:
+99°~ -99°C
Default Set:
200°C
Temperature correction value:
“00”
Soldering iron
306 K
Figure Dimension
150 x 145 x 102 mm (W x H x D)
Weight (Unit only)
2.5 kg
ACCESSORIES
Spare Iron Tips
•
T 2433
0.2 round
•
T 2434
0.8 round
•
T 2435
1.6 chisel
•
T 2436
3.2 chisel
•
T 2472
2.0 mini wave
