Micron Optics os3150, Руководство по установке

Страница: 5 / 10

Optical Strain Gages |
os3150 os3155
C o p y r i g h t © 2 0 1 3 M i c r o n O p t i c s , I n c .
o s 3 1 5 0 o s 3 1 5 5 I n s t a l l a t i o n G u i d e , R e v i s i o n C 5
Figure 6
– Surface Prep Area

Cover the sensor with a strip of Polyimide Tape as shown in Figure 7.

Cut a piece of STOPAQ and form it into a 1/8 inch [3mm] thick sheet. Wear gloves while handling the
STOPAQ material to prevent contamination from finger oils.

Cut 2 square pieces of STOPAQ Paste 1 x 1 x 1/8 inch [25 x 25 x 3mm]. Place one piece under the cable
near each end of the gage as shown in Figure 7.
Figure 7
– STOPAQ Paste Under Cable

Cut 4 rectangular pieces of STOPAQ Paste 1 x 1/2 x 1/8 inch [25 x 12 x 3mm].

Place a rectangle piece of STOPAQ Paste over each end of the gage adjacent to the cable and flush with
the vertical metal tab as shown in Figure 8.
Figure 8
– STOPAQ Paste on End of Gage

Cut 4 rectangular pieces of STOPAQ Paste 1/4 x 1/2 x 1/8 inch [6 x 12 x 3mm].

Pinch and work the two STOPAQ rectangles together forming one patch at each end of the gage as shown
in Figure 9.