Section
17
The program should be checked for accuracy BEFORE DRILLING as follows:-
7) Press BST once quickly.
a) End light will come on.
b) The bleeper will sound
continuous bleeps.
c) The target will not move.
8) Press BST once quickly
a) The END light will go off.
b) The bleeper will go off.
c) The target will position
over the last hole in the
program and the hole light
will come on, and the tool
display will show a "1"
to indicate the programmed
tool number.
9) Press BST once quickly
The target will move to the
previous hole in the program
and the bleeper will sound
as the button is pressed
and again, as the position
is reached.
10) Continue pressing BST.
The target will move from
( or hold BST down )
hole to hole until the first
command of the program is
reached when seven bleeps
will be heard.
The SST (Single Step) button is used in the same way as BST but will advance through the
program towards the end command. When this is reached, the END light will come on and
the bleeper will sound continuous bleeps. SST will have no further effect.
If the reset button is pressed while the machine is in the program mode (PROG button
depressed) the control system will re-enter the PROG mode on its release, and subsequent
SST commands will step through the program beginning with the first hole, or other
command, which was entered.
If any of the HOLE positions need to be altered they are simply repositioned after being
reached by using BST and SST and re-entered by pressing HOLE. Any other command
may be repositioned in the same manner. Care should be taken to re-enter the correct
TOOL number.
SST can also be used to SEARCH for a previously entered position. (See Section 9).
4
