BP3KN1-3B
11
IB BP3KN1-3B V4920 EN
EN
4. How do I get started?
4.1. Inserting the batteries
After you have unpacked your device, insert the batteries. The battery compartment is
located on the side of the device.
a). Remove the battery cover.
To open battery cover
: Turn the monitor over, locate the pull on cover and use your
finger tip to pull it towards you.
To close battery cover
: Align cover in the battery
compartment at approximately a 15 degree angle, inserting the tabs into the holes found
on the inside. Once the back of the cover has been seated, push down on the battery
cover pull.
b). The door will click into place.
c). Insert the batteries (2 x size AAA 1.5 V), following the indicated polarity.
If the battery warning appears in the display, the batteries are discharged and must be
replaced with new ones.
Attention!
• After the low battery indication warning appears, the device will not function until the
batteries have been replaced.
• Please use “AAA” Long Life or Alkaline 1.5V batteries. When replacing batteries, replace
all at the same time, and ensure they are correctly connected, as shown on the symbols in
the compartment.
If the blood pressure monitor is left unused for long periods, remove the batteries from the
device.
4.2. Selecting standard or MAM mode
Before each measurement, select standard (single measurement) or MAM mode (automatic
double measurement). In MAM mode, 3 measurements are automatically taken in
succession and the result is then automatically analysed and displayed. Because the blood
pressure constantly fluctuates, a result obtained in this way is more reliable than when a
single measurement is performed
•
After the new batteries are fitted, MAM mode ON/OFF selection will appear on the
display first. Press the M-button to select ON or OFF the MAM mode. Press the Time
Button to confirm and then select the Heart Level Indicator. To change to standard mode
(single measurement), press the Time Button until the MAM mode selection menu
appears and select OFF.
•
The bottom, right hand section of the display shows a 1, 2 or 3 to indicate which of the 3
measurements is currently being taken.
•
There is a break of 15 seconds between the measurements. A count down indicates the
remaining time.
•
The individual results are not displayed. Your blood pressure will only be displayed after