CFEWH SERIES 1-10
|
INSTALLATIoN
Manual ©2013
|
MicroHeat Technologies Pty ltd
13
12
Connection to Plumbing
The installation must comply with the relevant Australian Standards and Industry Codes: Plumbing and
drainage – Heated water services AS/NZS 3500.4
The Inlet (6) and Outlet (7) water connections are both ½” BSP SERIES GB.
Mount the appliance in a vertical position on an internal wall, or in an internal cupboard or space first – then
connect the hot and cold water to the appropriate connections:
Ensure the Inlet Filter (13) is installed as shown.
Mounting to the Wall (cont.)
Installation
Installation
15
Electric
Mains
Supply
Cable Gland
Fitting
IMPORTANT
When mounting the unit to a wall, it is very important that no holes are drilled within the
area shown below in RED.
The Cable gland Fitting hole (15) must not be opened out.
Holes drilled within this area, or opening out the Cable gland Fitting hole, will make the
unit inoperable and irreparable. It will also void the warranty.
7
13
INLET FILTER
HOT WATER
OUTLET
COLD WATER
INLET
6
Inlet (6) Cold Water – BLUE
Outlet (7) Hot Water – RED
The cold water supply pipe must be flushed before
connecting the cold water supply to the inlet (6).
Effective operation of the unit requires the hot water
outlet to be connected to the hot water faucet/valve.
