CFEWH SERIES 1-10
|
INSTALLATIoN
Manual ©2013
|
MicroHeat Technologies Pty ltd
11
10
Mounting to the Wall
The unit must be mounted onto a solid internal wall, or in an internal cupboard or space, in the vertical
position using the 4 x Mounting Screws (12) placed within the Mounting Screw Hole Locations as shown.
The maximum screw head diameter is
8mm. A screw head larger than 8mm will damage the mounting boss
and crack the body. THIS WILL VOID THE WARRANTY.
The mounting method used to fix the unit to a vertical wall must be capable of continuously supporting a
minimum weight of 10kg.
When mounting the unit onto a rough surface (ie: a brick wall or similar), a backing board should be mounted
to the wall first. The unit can then be mounted onto the backing board. This will allow the Exterior Cover (10)
to be properly fitted to the unit.
Exterior Cover Removal and Replacement
The procedure for removing the Exterior Cover requires the following steps:
Installation
Installation
WARNING
Body must
NOT be drilled,
note: "
NO DRILL" symbols
located on Flange
Mounting Screw
Hole Locations
6.7in
170mm
11.2in 285mm
5.3in
135mm
0.2in 4.4mm
6.6in
168.9mm
8.2in
207.6mm
12.3in
311.4mm
1.4in
35.5mm
3.9in
100mm
1.6in
39.5mm
12
When the Exterior Cover is about 45° from the Body,
reach into the unit and disconnect the LED Indicator/
Display PCB Plug and Cable (19) (See Page 17) from the
socket on the PCBA.
You can now lift off and separate the Exterior Cover
completely from the Body.
TO REPLACE THE ExTERIOR COVER, DO THE SAME
STEPS IN REVERSE AND THEN MOVE ONTO STEP 3.
Using a Phillips head
screwdriver, affix the Pan
Phillips Head Self Tapping
Screws x 2 (11) (provided
separately in the small
satchel) to secure the exterior
cover to the chassis. It is a
safety requirement to ensure
the unit cannot be easily
opened.
Find a clean flat surface and place the unit on its back.
Using both your thumbs and forefingers, grip the Exterior Cover (10) firmly along the bottom
of the unit, and push the cover slowly up to separate it from the Body of the unit.
IMPORTANT: DO NOT PULL COVER AWAy COMPLETELy jUST yET.
Step 2
Step 1
Step 3
