Microh ARENA COLOUR WASH, Руководство пользователя

Страница: 23 / 27

23
8. Error and Information Messages
This message appears if you try to switch the lamp on within 5 minutes after having switched it off as the lamp is too hot to re-strike.
The message will appear on the display if the lamp doesn't ignite within 28 seconds. The ARENA COLOUR WASH will store this
information and automatically attempt to ignite the lamp when the 5 minutes period has expired.
The fixture unsuccessfully attempted to ignite the lamp seven times (the HEAt message appeared six times before), and the display
shows "LAEr", meaning that the lamp could be damaged or even missing, the fixture is overheating (or the ambient temperature is
45° C or more) or that there could be a failure of the igniter or ballast.
Please replace or install the lamp, check the internal and external temperatures or contact your dealer if the situation was not caused
any of these.
This message informs you that the main PCB is not communicating correctly with the Control Panel.
(Colour wheel error) This message will appear after the fixture resets if the magnetic-indexing circuit malfunctions (sensor failed or
magnet missing) or the stepping-motor is defective (or its driver circuit on the main PCB). The colour wheel is not located in the
default position after the reset.
This error message informs you that the fixture was overheating (or the ambient temperature was 45° C or more) and that the relay
switched off the lamp. This message will appear on the display until the temperature has reached a suitable level, then the display
will show the HEAt message meaning the lamp is too hot to re-strike (see explanation above).
This message appears if the lamp lighting sensor has failed. Please contact your dealer.
This message will appear if the fixture was recently disconnected from the power supply.
(PAN-yoke movement error) This message will appear after the fixture resets if the yoke’s magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepping-motor is defective (or its driving IC on the main PCB). The yoke is not located in
the default position after the reset.
(TILT-head movement error) This message will appear after the fixture resets if the head’s magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepping-motor is defective (or its driving IC on the main PCB). The head is not located in
the default position after the reset
.
This message will appear if the frequency of the power supply is not standard 50 or 60 Hz.