14
Microframe Corporation
Series 5100 General Information
Microframe Corporation
Options Defi nitions
This section gives additional information about each
option introduced in the "Options Table."
Setup
1 Operation
This area determines the operation of the display.
1.4 Master - the standard TAN mode.
1.5 Lobby slaves - will display the same number as the
master. 1.6 MWTS slave - used over counter windows.
1.7 MWTS slave Manual Address - allows a secondary
display to be set up inside a counter window to echo the
display outside the window.
2 Display Size
The display looks at this area to see how many digits
it has. It is set at the factory to match the number of
digits of the display; i.e. a 3-digit display would have a
"3" in this area.
3 Leading Zero Suppression
The value in this area determines whether or not your
display will show leading zeros; i.e., the difference between
seeing "000001" on your display and seeing "1."
3.0 - Shows leading zeros
3.1 - Hides leading zeros
4 IR Lockout
This option causes the display to ignore the remote
control. This helps prevent accidental changes to displays
in a multi-display installation. To toggle IR Lockout
using the remote, hold the [EXIT] button for 5 seconds.
The display will indicate the change by showing "ir0"
or "ir1."
4.0 - Display will ignore the remote
4.1 - Display will respond to the remote
5 Internal Chime
This area controls how many times the internal
chime will sound.
5.0 – Off; no chime
5.1 – Single; chime once
5.2 – Double; two chimes
6 Chime Volume
The internal chime can be set to half or full volume.
0-4 Low, 5-9 High.
7 External Chime
This area controls the duration of the external chime
driver circuit. The external driver can be activated from
0 to 20 seconds.
Note:
The external chime option must be specifi ed at
the time of order. Dry contact (relay) and AC load (Triac)
drivers are available. The maximum input voltage is 24V
AC\DC. Typical uses include a triac driving a doorbell
chime, and a relay sending a control signal to another
device.
8 Display Address "Tens" Digit
This is used in the Multi-Window Service System con-
fi guration to set the address of Window Slaves; it stores
a value from 0-9. See the Multi-Window Service System
for further details.
9 Display Address "Ones" Digit
This is used in the Multi-Window Service System con-
fi guration to set the address of Window Slaves; it stores
a value from 0-9. See the Multi-Window Service System
for further details.
