MicroCool RHINO 15, Инструкция по установке и обслуживанию

Страница: 21 / 38

Master Rhino Manual_
March 2020.docx
March 20 Page 21 of 38
INLET WATER FILTERS
The inlet water filter cartridges, 5-micron and 10-micron, must be inspected once per week or as needed (See
page 27). The change interval of the filter cartridges depends entirely upon the cleanliness of the inlet water.
When the “outlet gauge” shows a significant drop in pressure during operation it is time to change the filters. The
filter cartridges should be changed at least once every year.
Re-ordering Information
ATOMIZATION LINES/MANIFOLD HOSES
The hoses and lines should be periodically inspected for damage such as cuts and abrasions. Also check that the
hoses have not come into contact with sharp edges or are vibrating against an abrasive surface.
SYSTEM FLUSH – SHUT DOWN - WINTERIZING
If the system is to be SHUT DOWN for a period of time, all automatic drain valves or end plugs should be removed
and the complete system flushed. Then all water remaining in the lines should be purged with compressed air. The
supply water to the pump module should be turned off. Empty filter housings of any remaining water and replace
filter cartridges with new dry cartridges. Turn off electrical power to pump module. This will help to prevent water
freezing and damaging the pump or its components.
INLET WATER PRESSURE SWITCH
The pressure switch is a hydraulically actuated, stainless steel enclosed switch. It is complete with platinum coated
contacts that complete a 24vac control circuit. The body of the pressure switch has a 500 P.S.I. (34.5 BAR)
maximum pressure rating. Switches are preset at factory at 10 PSI (0.7BAR).
20”- Big Blue 4.5” 25 Micron Filter
Part # PFB2005