1.
Introduction
1.1
Features
The following are key features of the PIC32CM JH01 Curiosity Pro evaluation kit.
• 100-pin TQFP PIC32CM5164 JH01 microcontroller
• Embedded Debugger
– micro-USB interface
– Auto-ID for daughter board identification in MPLAB X IDE
– One yellow status LED
– One green board power LED
– Symbolic debug of complex data types including scope information
– Programming and debugging of on-board PIC32CM JH01 through Serial Wire Debug (SWD)
– Data Gateway Interface: SPI, I
2
C, and four GPIOs
– Virtual COM port (CDC)
– Control of on-board power switch to protect connected extensions against high voltage
• Digital I/O
– Two mechanical buttons (user and reset button)
– One driven shield Touch button
– One yellow user LED
– Three extension headers compatible with a wide range of Xplained Pro extension kits
– Arduino uno connector
• Two selectable target voltages
– 3.3V
– 5.0V
• Voltage Level Shifters between target section and EDBG section
• 32.768 kHz crystal mounted
• 32 MHz crystal mounted
• Trust Anchor (TA100) Secure Element
• Two CAN transceivers with jumpers for connection to external device or loopback between the two CAN
interfaces
• LIN transceiver
– Wake-up button
– Host node pull-up jumper
– Alternate LIN power jumper
• DAC output connector
• Analog voltage reference connector with filtered power supply
– ADC/DAC VREF
• 5-pin Position Decoder (PDEC) connector
• Supported with application examples in MPLAB Harmony v3
EV81X90A
Introduction
©
2022 Microchip Technology Inc.
and its subsidiaries
User Guide
DS70005482B-page 3
