micro-trak SprayMate XRS, Системное руководство

Страница: 9 / 31

9
A
B
C
RED
BLK
Co12VDC
Sw12VDC (Signal)
Ground
Various
3-Pin
Weather Pack
Tower
Connector
WIRING HARNESS ORIENTATION
Wiring with multiple branches MUST be installed so that the individual wires point downward, as shown on right below.
This will protect the internal connections from exposure to liquid chemicals.
Installation
Console Mounting - Power Connection - Section Wiring
Select a mounting location that is practical and convenient. It should
be easy to reach and highly visible to the operator. DO NOT INSTALL IN
A POSITION THAT OBSTRUCTS THE VIEW OF THE WORKING AREA.
Whenever possible, avoid locations that expose the console to direct
sunlight, high temperature, strong chemicals or rain.
Place the mounting bracket in the selected location, mark holes, drill
¼” (7mm) holes and mount bracket with bolts, lock washers and nuts
provided. (Use self-tapping screws if not practical to use bolts.)
Position the console bracket inside the mounting bracket and fasten with
wingnut. Install the console knobs through the bracket, placing a rubber
washer over the threaded stud. Position console to proper viewing angle
and tighten the knobs securely.
This section explains how to connect the Spraymate XRS controller to a 12VDC power connection and wiring information
about section shut-off valve connections. The Spraymate XRS controller must be connected to a 12VDC negative ground
electrical system.
ROUTING HARNESS AND CABLING
Avoid ar eas where the ca ble may be sub ject ed to abra sion or
exces sive heat.
POWER/BATTERY CONNECTION
Locate the power cable leads on the Spraymate XRS controller
power cable and route them to the battery. At tach the BLACK
wire to ground. Connect the ORANGE wire to the positive battery
terminal. Be sure there is good metal-to-metal con tact. See
illustration.
Connect the power to the SprayMate XRS console by plugging the
2-pin W/P tower on the power cable into the 2-pin M/P shroud
connected to the wiring harness.
+12 VDC
10A in-line fuse
(+)
(–)
Ground
(Black)
(Red)
(Orange)
SECTION SHUT-OFF VALVES
The Spraymate XRS wiring includes connections for
2 section valves. The wiring to each Weather Pack
connector consists of +12VDC, Ground, and switched
+12VDC.
See Illustration.
Verify the wiring layout of your valves
before
connecting
them to the system. Please refer to original valve
documentation or contact valve manufacturer if you are
unsure of the correct wiring configuration.