Page 32
optoCONTROL 1202
7.
Calibration
A detailed description of the system calibration for the width-/ thickness measurement, mode “Width“, you
will find in the software description.
8.
Warranty
All components of the device have been checked and tested for perfect function in the factory.
In the unlikely event that errors should occur despite our thorough quality control, this should be reported
immediately to MICRO-EPSILON Eltrotec. The warranty period lasts 12 months following the day of shipment.
Defective parts, except wear parts, will be repaired or replaced free of charge within this period if you return
the device free of cost to MICRO-EPSILON Eltrotec.
This warranty does not apply to damage resulting from abuse of the equipment and devices, from forceful
handling or installation of the devices or from repair or modifications performed by third parties. No other
claims, except as warranted, are accepted. The terms of the purchasing contract apply in full.
MICRO-EPSILON Eltrotec will specifically not be responsible for eventual consequential damages.
MICRO-EPSILON Eltrotec always strives to supply the customers with the finest and most advanced equip-
ment. Development and refinement is therefore performed continuously and the right to design changes
without prior notice is accordingly reserved.
For translations in other languages, the data and statements in the German language operation manual are
to be taken as authoritative.
9.
Service, Repair
In the event of a defect in the controller, light source, receiver or
the sensor cable, the complete system must be sent back for
repair or replacement.
In the case of faults the cause of which is not clearly identifiable,
the whole measuring system must be sent back to:
MICRO-EPSILON Eltrotec GmbH
Manfred-Wörner-Straße 101
73037 Göppingen / Germany
Tel. +49 (0) 7161 / 98872-300
Fax +49 (0) 7161 / 98872-303
www.micro-epsilon.com
