MICRO-EPSILON colorCONTROL MFA-5, Инструкция по эксплуатации

Страница: 41 / 80

Page 41
Operation
colorCONTROL MFA-5
Example 2:
If you want to assign the offsets of one checkpoint only partially or completely for the other checkpoints, you
must deactivate the checkbox of the Configuration window.
At the same time, deactivate the checkbox in the
Settings for Sensor
window for each checkpoint
for which you want to assign the offset.
The checkbox in the Settings for Sensor window must remain activated for the checkpoints where the
old offset setting should be retained.
Now select the checkpoint whose parameters should be applied by clicking on it.
Check whether the checkbox in the
Settings for Sensor
window is also deactivated.
Then press the Change all settings button after selecting the checkpoint.
Now perform a test using the
Measurement
window to apply the reference values.
i
Changes relating to the offset and checkpoint settings are always not applied until after performing a
new test using the List of measurements window.
5.2.4.4 Reset of Offset Settings to the Factory Settings
Use the Reset Board command on the Test pop-up menu to restore the factory settings of the color-
CONTROL MFA-5.
Now disconnect the colorCONTROL MFA-5 using the Disconnect button.
Restart the software to apply the condition as delivered.