MCS-THERMOSTAT
REVISION 1.5
11
7. Wiring Instructions to MicroMag (Rev. 6.1 or greater)
Begin wiring (not supplied) from the
MCS CONTROLLER
to the
MCS-THERMOSTAT
as seen in the wiring diagram below.
ONE THERMOSTAT PER MCS-CONTROLLER
TURN POWER OFF TO CONTROLLER AND
THERMOSTAT FIRST
MCS THERMOSTAT
Enlarged view of Thermostat block wiring
MicroMag Sensors
5 Sensors available
Power for Thermostat
(can be wired to any empty sensor)
R
(+5)
B
(GND)
MicroMag
I/O port
NOTE:
Termination jumpers
are used only on the
first and last
boards on the network
G
(MCS)
W (+)
