MCS-THERMOSTAT
REVISION 1.5
17
12.
Config Menu Settings
CLICK ON MENU - USE
DOWN BUTTON TO SEE THE CONFIG MENU
AUTHORIZATION PASSWORD MAY BE REQUIRED
NOTE: SOME MENU SELECTIONS MAY NOT SHOW ON YOUR THERMOSTAT LCD SCREEN.
THESE SELECTIONS MAY NOT BE SETUP IN THE CONFIGURATION FILE FOR YOUR CONTROLLER.
12.1. AUTH LEVEL SETUP
Authorization Levels- The thermostat allows three levels of passwords -
Service, Supervisor,
and
Factory
.
12.2. UNIT = DEGREES
Hit ‘ENTER’ -Allows the user to change between Celsius and Fahrenheit.
Directions: Use the Up/Down arrows to move between Celsius and Fahrenheit. Press
‘Enter’ to select the desired unit degrees and the display will confirm the change.
12.3. MODIFY SCHEDULES
Unlike Thermostats that are used at home and in an some office buildings, the MCS
Thermostat ‘SCHEDULES’ control the run/stop of the controller’s cool target and heat
target setting only.
Think of the Thermostat ‘SCHEDULES’ as controlling whether a building or room is
‘OCCUPLIED or ‘UNOCCUPLIED’.
We can still allow the building or room to be cooled or heated, but with target setting,
we can lower (or raise) the temperature depending on whether the building or room is
‘OCCUPLIED’.
For example if you set ‘SCHEDULE ONE’ to start at 8:00am the thermostat will start
either the cooling process or heating process of the unit based on the cooling/heating
targets that you have setup in the Thermostat or configuration of the controller. Setting
‘SCHEDULE ONE’ to end at 17:00 (5:00pm) the Thermostat can change how the
building or room is heated or cooled.
The advantage of the MCS Thermostat is that you can override the target settings
of the UNIT’S heating, cooling and humidity from the thermostat without the going to
the actual unit. See an example of setting up the schedules and holidays on the next
pages.
MENU
Config Menu
Occup
NOTE: IF THERMOSTAT SHOWS
LOCKED ICON, NO CHANGES
CAN BE SAVED UNTIL YOU
BECOME AUTHORIZED
SHOWS UNLOCKED
MENU
Config Menu
Occup
