8 | www.mhpgrills.com
The grill head should not be attached to the column until the
base has been permanently mounted to a flat and level deck or
patio surface. Not recommended for use on patio pavers.
ATTACH THE BASE TO THE COLUMN (OP BASE) continued
STEP 3B-OP
•
Choose a location where you are going to set
up your grill. Make sure the surface is flat and
level and be certain that there are no combustible
materials above, behind, left or right closer than
18" away.
•
Insert a Lag Bolt into the two pre-drilled holes
located around the center cutout on the OP base.
•
Securely tighten lag bolts so that base and column
are stablized.
•
Choose a location where you are going to
set up your grill. Make sure the surface is flat
and be certain that there are no combustible
materials above, behind, left or right closer than
18" away.
•
Run your natural gas line through the notch
located on the back side of the OP base and
continue it up through the center cutout.
Directions for connecting the natural gas line
to the GCTSS flexible tubing is outlined in
Step 3B-OP on page 12.
•
Insert a Lag Bolt into the two pre-drilled holes
located on the sides of the center cutout of the
OP base.
•
Securely tighten lag bolts so that base and
column are stablized.
LAG BOLTS (2)
Not supplied by MHP
Use appropriate
Lag Bolts for
your application
HARDWARE NEEDED
SECURE THE BASE (FOR LP GAS INSTALLATIONS)
SECURE THE BASE (FOR NATURAL GAS INSTALLATIONS)
NOTCH FOR
NATURAL GAS
NATURAL
GAS LINE
CENTER
CUTOUT
LAG BOLT HOLES
LAG BOLT HOLES
