www.mhpgrills.com
| 13
The gas supply line must be regulated (in the case of
natural gas that means it should be connected after your
gas meter and regulator) and you must have an easily
accessible main shut-off valve to your grill’s gas
supply. Grills are designed to operate on a pressure
of 7" w.c. in. for Natural or 11" w.c. in for Propane at the
grill valve connection.
When installing a new gas line, it is recommended that you contact a plumber, heating contractor
or licensed gas fitter to install your new gas line to meet local building code. Be certain there are no
combustible materials closer than 18" away (above, behind, left or right) from your assembled grill.
Attach Natural Gas Line to the GGCTSS Flex Tube
•
Connect a 3/8" flare coupling (not supplied by MHP) to the
gas supply line then the flexible stainless-steel tubing
(GGCTSS) using a 3/4" wrench. The use of two wrenches is
recommended—one wrench is used to hold fitting while the
other is used to tighten.
Tighten very securely as flare fittings are
a metal-upon-metal surface seal and no
additional gas sealant is needed.
GGCTSS
GAS
SUPPLY
LINE
CONNECT THE GAS LINE (FOR NATURAL GAS INSTALLATIONS)
3/8" FLARE
COUPLING
(Not supplied
by MHP)
CONNECTING THE GAS SUPPLY LINE (OP BASE) continued
STEP 5C-OP
Attach the GGCTSS Flex Tube to the
Gas Valve
•
Attach the swivel connector end of
the GGCTSS Flex Tube to the gas
valve located under the control panel.
•
Make sure your gas line runs through
the hose retaining notch opening and
continues under the shelf as shown.
•
Tighten all gas connections
securely. The use of two wrenches
is recommended—one wrench is
used to hold fitting while the other
is used to tighten.
•
Before using your grill check for
any gas leaks with a soap and water
solution before using your grill.
HEAT SHIELD
GGCTSS
FLEX TUBE
GAS VALVE
SWIVEL
CONNECTOR
HOSE RETAINING
NOTCH OPENING
TOOLS NEEDED
3/4" OPEN END
ADJUSTABLE
WRENCH
PARTS NEEDED
GGCTSS
FLEX TUBE
3/8" FLARE COUPLING
(Not supplied by MHP)
