14
15
- Inserting and removing the battery
- Switch lock
• Always have drill rotation switch in neutral/lock position when removing or inserting
battery to avoid unintentional starting.
• To insert, simply push pack in until lock spring clicks.
• To remove battery pack from the tool, press the lock spring buttons (d in the functional
description) and pull out.
• The switch trigger can be locked in
the center position.
• This helps to reduce the possibility of
accidental starting when not in use. To
lock the switch trigger, place the
direction of rotation selector in the
center position.
SWITCH (E in the functional description)
The drill is started and stopped by depressing and releasing the ON/OFF switch trigger.
- Rotation direction
• Direction of rotation is controlled by
the direction of rotation selector
located above the switch trigger.
• Right: To select forward rotation,
forward/reverse lever to the left side of
the tool.
• Left: To select reverse rotation, push
the lever to the right side of the tool.
• This tool has a variable speed switch that delivers higher speed and torque with
increased trigger pressure.
• Speed is controlled by the amount of switch trigger depression.
- Variable speed
NOTE: Mark “1”is Low speed position, mark “2” is High speed position that moulding
onto the button of two speed selector .
• The drill has a two-speed gear train designed for drilling at 1 (LOW) or 2 (HIGH) speed. A
gear selector is located on top of the drill to select either low or high speed. When you
push the button forward and select low speed range, the speed will decrease but will
provide more power and torque. When using drill in the high speed range. Speed will
increase but will provide less power and torque. Use low speed for high power and
torque application and high speed for fast drilling applications.
Important: NEVER adjust this two speed selector whilst the drill is running. Always let it
come to a complete stop first.
Torque Regulator
Mode Selector
• This is a 16+1 position ring (B in the functional description) situated between the chuck
and the drill body.
• When arrow on the top of the housing points to 1 on the Torque indicator scale, torque is
at minimum before the clutch disengages the chuck from the drive.
• When indicator is just past 16, output is at maximum before it is disengaged. This is
• More torque will set a screw deeper into material, less torque will prevent it stripping.
Larger screws require more torque to drive than small ones. A little trial and error will
show you which is the optimum setting for the situation.
• Release the trigger when the clicking sound indicates the chuck will not turn further.
• For drilling, always use the drill setting, indicated by the pictogram of a drill bit at this
setting, the drive does not disengage from the chuck.
20V ULTRA Drill 2Ah KIT
(MH-03-D-B1-0-1)
20V ULTRA Drill 2Ah KIT
(MH-03-D-B1-0-1)