MFJ MFJ-950K3, Инструкция по эксплуатации

Страница: 6 / 8

Figure 8
12. Start reassembly of the K3 by reinstalling the right side panel by installing the 4-40x3/16 screws
removed in step 6 (see Figure 4).
13. Reinstall the 4-40x1/4 Zinc pan head screw and lock washer holding the tuner board to the
spacer attached to the right side panel and the black 4-40x3/16 flat head screw that holds the
side to the back panel. (See Figure 3).
14. Reinstall the black 4-40x3/8 flathead screw, lock washer, and nut removed from U12 and U13.
(See Figure 2.)
Figure 9
15. Bring the cover to the radio and hold over the radio, carefully plug in the speaker connection into
P25 on the KIO3 board oriented in the way that the diagram shows in Figure 9.
16. Position the top cover on the K3 with the tabs on the cover going under the rear lip. Secure the
cover with the nine black flathead 4-40 screws that were removed earlier.
17. Verify all screws have been reinstalled and are tight.
KIO3 Board in Left
Rear corner of the
chassis.
Orient connector
as shown