MFJ MFJ-950K3, Инструкция по эксплуатации

Страница: 3 / 8

Installation
1. Disconnect all power and cables from the K3
2. Remove the 9 screws holding the top cover. The screws to remove are marked with arrows in the
diagram. Do not remove the unmarked screws.
Figure 1
3. Open the cover and carefully unplug the speaker wire.
4. Remove the hardware securing U12 and U13 to the side panel. Do not lose the lock washers and
nuts inside the K3.
5. Remove the screw and lock washer holding the KANT3 board to the spacer and the screw
holding the rear panel (marked with arrows).
4-40 Screw
Side Panel
Regulator
Internal Tooth Lock Washer
4-40 Nut
Figure 2