MFJ MFJ-950K3, Инструкция по эксплуатации

Страница: 5 / 8

Flex the back a little to allow the board to clear.
8. Rock the KANT3 board and pull up to remove it
from the connector. Flex the back a little to help
the board clear the back panel.
Hole Plug and tabs to squeeze to release the plug.
9. Remove the plug in the hole for the ANT2
connector. Squeeze the tabs in to release the
connector from the back panel.
10. Install the new SO-239 connector using the included hardware
in the hole where the plug was. Tighten the screws tight but not
over tight. Loose screws can cause noise problems.
New RF Connector
11. Install the MFJ-950K3 tuner board into the P3 socket that the KANT3 board was plugged into.
Support the tuner board while plugging in the antenna connections.
Figure 7
Figure 6