Meyra 1.610, Руководство по техническому обслуживанию и ремонту

Страница: 23 / 104

23
BACK SUPPORT
Mounting the push bar
The single push handles [1] can be replaced by the push
bar [2].
Therefore unscrew the screw (3) at both sides.
Mounting the stabiliser rod
The stabiliser rod (4) can be mounted to the two attach-
ment points (5) of the back tubes.
The seat width adjustment can be carried out after disman-
tling the screws (6). In doing so the brackets on both sides
are to be repositioned at the same rate.
3 Stabiliser rods are available.
1. for seat width 30 / 34 / 38 cm
2. for seat width 38 / 43 / 48 cm
3. for seat width 48 / 53 / 58 cm
☞
The stabiliser rods can be adjusted within the indicated
range of seat widths.
Adjusting the seat depth
The seat depth can be changed by moving the back sup-
port to a different position.
For this the three attachment screws (7) are to be removed
on both sides.
☞
Parallel repositioning of the back support.
☞
For this observe chapter Depth adjustment of the
arm support pad
on page 21 and chapter
Seat
depth on page 30.
3
5
6
4
7
7
1
2