Meyra 1.610, Руководство по техническому обслуживанию и ремонту

Страница: 69 / 104

69
Plug allocation of the lighting/adjustment module
R-Net
Overview of the plug allocation of the lighting/adjustment
module R-Net [5]:
(a) R-Net Bus
(b) R-Net Bus
(c)
left lighting
(d) right lighting
(e)
adjustment motor: electric back support
(f) adjustment motor: camber
(h) adjustment motor: left leg support
(g) adjustment motor: right leg support
(j)
adjustment motor: seatlift
(k) adjustment motor: Recaro 12 V
(l) Inhibit 4: switch seatlift (without seatlift the blind plug
item no. 1071671 must be inserted)
(m) Inhibit 5: Tilting switch
Lighting module VR2
The lighting module VR2 (6) is used in combination with
the operating module VR2 and mounted beside the power
module onto the frame plate (model 1.610 / 1.611 / 1.615 /
1.616) [7] resp. fastened onto the power module with velcro
straps (model 1.612).
Electronic driving stability sensor (ESP)
The driving stability sensor (ESP) is attached to the front
right onto the main frame with angled mounting plates (8).
☞
Retrospective fitting of the electric wheelchair with a
driving stability sensor may only be carried out at our
site!
Replacing the driving stability sensor
1. Pull the connector cable of the driving stability sensor.
2. Unscrew the driving stability sensor onto the main
frame with the angled mounting plate.
3. Mount the new driving stability sensor with the angled
mounting plate in the same place.
!
Attention:
Assembly of the driving stability sensor is only permit-
ted in the assembly position shown. Other assembly
positions lead to a malfunction of the driving stability
sensor!
4. Re-establish the electric connection.
5. Switch the electric wheelchair off and on again.
6. Conduct a driving test.
6
l j g e c a
m k h f d b
8
5
7