-6-
The Shake (SHK) button when pressed will shake the plow left
and right for three seconds. This function is used to shake off
any snow which may be stuck to the plow. This function is only
available within the last ten seconds of an angle, raise or lower
operation.
Using the “Mount” button
The Mount (MNT) button when pressed will turn on the
Mount/Dismount Mode. In this mode the Mount/Dismount
Switch on the hydraulic unit is activated and no other snow
plow functions will be available. To confirm that the Mount/
Dismount switch is in the Mount/Dismount Mode all controller
buttons will illuminate and flash. The buttons on the controller
will continue to flash until the Mount (MNT) button is pressed
again turning the Mount/Dismount mode off.
Activation of the Mount/Dismount Switch for longer than
15 seconds at a time will shut down the Mount/Dismount
operation. Release of the toggle switch momentarily will allow
activation to continue. This is an enhanced feature used in the
Hand Held Controller for all snowplow functions. This feature
eliminates unnecessary amp draw from the vehicle charging
system when operating the snow plow.
Monitor Light
The Hand Held Controller is intelligent and will assist in
diagnosing electrical problems. The Hand Held Controller
continually monitors the snow plow system during plow
operation. When the Hand Held Controller recognizes a
potential problem the Monitor Light will begin to flash. The
Monitor Light is located in the upper left hand corner of the
controller next to the Float indicator light.
Counting the number of flashes and using the diagnostic
chart located on the back of the controller will help locate the
component part that is causing the malfunction. See chart
below.
See page 11-13 for more trouble shooting information.
The Hand Held Controller can be reset by the controller being
turned off momentarily and then back on again.
Note: If Monitor light is still illuminated after attempts to reset
the controller, please contact your nearest authorized Meyer
Distributor for repairs.
Drop
Adjustment
Top Hose
Mount Ram
Hose
D.S. Ram
(Right Angle)
Bottom Hose
Mount Ram
Hose
P.S. Ram
(Left Angle)
"C"
Green Wire
(Right Angle)
"D"
Yellow Wire
(Left Angle)
Not Energized
(Mount)
"E"
Purple Wire
(Dismount)
"B"
Red Wire
(Raise)
"A"
Black Wire
(Lower/Float)
