1. Aggressor™ Moldboard
Made from 12 or 14 gauge steel, 6 vertical ribs. Painted with the
Meyer Sno-Flo® Powder Coat, that is a baked on finish that looks
like glass, provides an extremely hard, low friction surface that
outlasts ordinary paint by a large margin.
2. Cutting Edge
Replaceable, high carbon steel provides extra long operating life;
should be 1/2” above ground in plowing position. (Can be higher
when used on gravel driveways.)
3. Runners
Mushroom replaceable runners hold cutting edge at proper height.
4. Trip Springs
Allow moldboard to trip forward and ride over obstructions, this
protects the snowplow, vehicle, and operator.
5. Pivot Bar
Positions moldboard straight across, angled right or left.
6. Pivot Pin
Pin that attaches the moldboard to the pivot assembly.
7. Power Angling Cylinders
Positions the moldboard hydraulically at all angles.
8. Mounting Cylinder
Allows Plow Assembly to
be installed and removed
in seconds.
9. Push Frame
Allows the Snow Plow Push Frame attaching point to transfer the
power from the vehicle frame to the snow plow. Always keeps the
plow level in any angled positions
10. Lift Frame
Allows for fast, complete removal of snow plow, snow plow lights
and hydraulic unit in one complete module. Lift Frame will stay on
the vehicle.
11. Lift Arm
Chain locks in position to lift snow plow.
12. Meyer Snow Plow Lights
Complies with the Federal Motor Vehicle Safety Standards.
13. E-68 Electric Hydraulic Power Unit
Operates snow plow hydraulically—raises, lowers, angles, holds and
floats moldboard in plowing position. Mounts and Dismounts plow
assembly from vehicle.
Get to know your Meyer
®
Snowplow
-2-
INSIST ON GENUINE MEYER PARTS & ACCESSORIES
• Protect your warranty
• Made to Meyer specifications • Fit right
• Wear longer
• Perform better
• Your best value
