SNOWPLOW HAND HELD
CONTROLLER OPERATION
To turn the controller on, press the on button located in the upper
right hand corner on controller.
The snowplow should only be in operation when the vehicle
ignition switch and the hand held controller are in the “ON”
position. Care should be taken to insure that the hand held
controller is kept dry and free from moisture during normal
operation.
When the hand held controller is turned “On,” lights illuminate
all buttons.
Lowering of the snowplow an inch at a time is possible by
tapping the down arrow in short intervals. Holding down the
down arrow for 1 second will activate a float light to the left of
the on/off button. This light indicates the snowplow is now in the
Lower/Float position. In this position the snowplow will be able
to follow the contour of the road and the snowplow can also be
angled to the left or right. Touching the up arrow automatically
cancels the Lower/Float position.
Note:
To regulate the lower speed, locate the Lower Adj. Screw
on side of angling block. Loosen locking Nut Screw in to slow
down or out for faster lower speed. See form 1-878 (E-68) for
more details.
-5-
On
Right
Up
Left
Down
While angling left or right or raising the snowplow if the button
is pressed for more than four seconds the operation will be
cancelled. This feature eliminates unnecessary amp draw from
the vehicle charging system.
The auto lower (ALM) button when pressed will illuminate the light
above it and allows the plow to lower automatically when the
vehicle is shifted into reverse and raise automatically when shifted
out of reverse. To turn off the auto lower mode simply press the
auto lower button again and the ALM light will go out.
