Meyer Drive Pro LD, Руководство владельца и руководство пользователя

Страница: 7 / 26

5
STEP 2a
Carefully route the Vehicle Harness to the vehicle battery (fig. 12). You may
need to route thru the grille or behind/under the bumper. Be sure to stay
away from hot, sharp or moving parts of the vehicle and use the zip ties
provided to secure. Attach the BLACK wire to the negative (-) battery post
(fig. 13) and the RED wire to the positive (+) battery post (fig. 14).
STEP 2b
Carefully attach the Vehicle Harness Extension to the vehicle harness (fig.
15) and route extension into the vehicle. For wireless remote control mod-
els, plug receiver box and secure with zip ties (fig. 16). The extension can
either be routed thru the firewall (fig. 17) or along the hood channel (fig.
18) and thru the window or door jamb (fig. 19). Be sure to stay away from
hot, sharp or moving parts of the vehicle and use the zip ties provided to
secure. If routing thru window or door make sure the hood, door or window
closes without pinching or cutting the harness. Connect the Controller to
the Harness Extension (fig. 20).
STEP 2c
IInstall your Receiver Hitch Mount (sold separately, see hitch require-
ments on pg. 4) per manufacturers instructions. Measure center of square
hitch to the ground. This dimension (A) should be a minimum of 25.4
cm and a maximum of 33 cm (fig. 21). Measure from the hitch pin hole
to the very end of your bumper. This dimension (B) should be not more
than 21 cm (fig. 21). If your dimension does not fall within these ranges
you should contact your hitch dealer/manufacturer for height or length
adjustment accessories.
(A) 25.4 cm -33 cm
(B)
21 cm
STEP 2:
WIRING INSTALLATION
(Fig. 21)
(Fig. 12)
(Fig. 13)
(Fig. 14)
(Fig. 15)
(Fig. 17)
(Fig. 18)
(Fig. 19)
(Fig. 20)
(Fig. 16)
24, 25, 26, 27, 28 9, 20, 21
SAFETY PRECAUTIONS - See pages 2-3 for definitions