Meyer Drive Pro LD, Руководство владельца и руководство пользователя

Страница: 17 / 26

15
Grease
Grease
Grease POST-SEASON SUMMER MAINTENANCE (HYDRAULIC)
1. Draining & Replacing The Drive Pro LD Meyer M-1 Hydraulic Fluid
Drain the fluid by un-bolting the hydraulic unit from the Lift Frame and removing the
Reservoir Breather. Turn the hydraulic unit upside down and drain the fluid from the
reservoir. To drain the fluid from the power angling cylinders (if equipped), disconnect
the fittings and completely retract the cylinder rods and purge cylinder and hose of
all hydraulic fluid. The complete system should then be flushed out with Meyer M-2
Flushing Fluid before adding new Meyer Hydraulic Fluid. To flush the unit, re-install
the hydraulic unit to the Lift Frame and hose to the angle cylinder (if equipped). Add
1 quart of M-2 Flushing Fluid to the reservoir and replace the Reservoir Breather.
Cycle the unit Up, Down, Left and Right 5 times in each direction. Then drain the
hydraulic unit as before and re-fill with Meyer M-1 Fluid. Check fluid level after
cycling plow and top off if necessary.
2. Meyer M-1 Hydraulic Fluid is specially formulated with an anti-ice additive for almost
constant viscosity in subzero temperatures. Because it is free-flowing in extreme cold,
the unit’s performance and efficiency are not affected by winter weather. It is effective for
a maximum of one year. Always carry an extra quart of Meyer M-1 Hydraulic Fluid. Use of
any inferior fluids will void Drive Pro LD warranty.
SNOW PLOW STORAGE
1. When snow plow is disconnected, disconnect lift chain from lift arm and extend lift
cylinder to end of stroke and coat chrome rod with light grease. This fills the cylinder
with hydraulic fluid and protects the interior and exterior from rust and corrosion.
2. Whenever Moldboard is disconnected, coat the exposed portions of the power angling
cylinder chrome rod (if equipped) with light grease to protect it from corrosion.
3. Coat pivot pin and other wear points with chassis lubricant. Be sure to grease all
grease holes.
4. Unplug electical connection. Coat connection with a dielectric compound to prevent
corrosion and plug into their corresponding weather plug.
Yellow and black paint is formulated
to withstand harsh temperatures and
the winter environment. Protect your electrical system
with Meyer winter formula
dielectric grease. Meyer M1 Hydraulic oil and M2 Flush
is scientifically formulated to withstand
extreme winter temps up to -40C.
Dielectric Grease
24, 30 7, 9, 12, 13, 15, 16, 17, 19, 20, 21
SAFETY PRECAUTIONS - See pages 2-3 for definitions