Meyer AG-10, Руководство по эксплуатации и обслуживанию

Страница: 6 / 45

CRANKSTAND STORAGE
To store Crankstand on the Lift Frame slide the tube that is attached to the
side of the Crankstand over the receiver tube on the driver’s side of the Lift
Frame. Insert the chain locking pin through the vertical holes on both the
tubes. Note: Crankstand should always be fully retracted (up) and be
pinned in the vertical transport position when not in use. Receiver Tube
Cap may be placed over the driver side transport tube while the Crankstand
is in use on the A-Frame. The Receiver Tube Cap may also be switched over
to the Adjustment Tube of the A-Frame when the Crankstand is mounted to
the Lift Frame.
Storage of the Crankstand is the responsibility of the operator. The
stand can be stored on the lift frame in the retracted position to the
driver’s side transport tube or inside the vehicle cab.
HYDRAULIC COVER
Install Black Hydraulic Cover before installing the Lift Assembly to the Lift
Frame. Begin by sliding the Hydraulic Cover down over the Lift Ram. Slide
the side covering the motor carefully over the motor, do not force or stretch
the Hydraulic Cover it will fit comfortably over all parts of the Hydraulic Unit.
Feed the three coil wires (red, green and black) through the hole located on
backside of cover. Route coupler weather plugs through holes in cover where
power angling hoses enter. Snap Cover together. Caution: Care should be
taken with the installation and or removal of the Hydraulic Cover, including
partial removal when repairs are performed on the Hydraulic Lift Unit. Tearing
of the Hydraulic Cover for any reason will not be covered under the Meyer
Warranty.
ATTACHING MOLDBOARD ASSEMBLY ONLY
Attach A-Frame to Lift Frame by connecting Crankstand to the adjustment
tube in the center of the A-Frame Frame. Insert the chained locking pin all
the way through the vertical holes on both the tubes. Crank up A-Frame until
the holes on the back ears of the A-Frame are about 12" off the ground. Pull
out the Yellow Handle Pins on both sides of the Lift Frame. Twist handle
slightly to the right or left disengaging the pin. Pull truck up to the A-Frame/
Moldboard assembly aligning the A-Frame ears between the two lift frame
plates until contact is made with the Clevis Frame. Once you feel contact,
push the moldboard assembly a few inches forward, this insures proper
alignment so that the A-Frame is square to the Clevis Frame. Adjust the
Crankstand up until the front of the truck raises slightly. Rotate the Yellow
Handled Pins so that the small leg realigns with the slot, engaging the pin.
The spring loaded pin should snap into place locking the A- frame to the lift
frame. Note: If pins do not properly engage move the truck slightly forward
a few more inches and/or adjust (raise or lower) the Crankstand until pins
lock into place. If only one pin should engage, retract the stand to the full
upright position. Remove the Crankstand from the A-frame by removing the
chained locking pin. Reattach the Crankstand to the transport tube on the
driver’s side of the Lift Frame in the vertical transport position. Attach the
Lift Chain to the Lift Arm through the two hooks on the lift arm. Adjust the lift
chain at the lift arm so that there are 2-3 links of slack. This ensures that the
plow blade will lift fully and be able to follow the ground contour while plowing.
Raise the plow with the hydraulics and swing the moldboard slightly left or
right until the pin engages.
4