Meyer AG-10, Руководство по эксплуатации и обслуживанию

Страница: 20 / 45

be necessary to allow the unit to cool down for approximately 2
minutes. If the overload light is still illuminated after attempts to reset
the switch have failed, contact your nearest authorized Meyer
Distributor for repairs.
Note: On Model E-60 only to regulate the lower speed, locate the lower
adj. screw on Page 20, Fig. 0-3. Turn adj. screw in to slow down or out
for faster lower speed. Adjustments must be made with moldboard
on the ground. This feature is not available on model E-57.
CAUTION: When the snow plow is not in operation, the Electro
Touch® Control Switch should be in the "OFF" position.
Over-the-Road Operation
WARNING
Based on the experience of our representatives and other background,
we advise a maximum transporting speed of 40 m.p.h. or locally
regulated speeds, whichever is less, dependent upon road conditions.
The operators should, of course, maintain a safe stopping distance and
adequate passing clearance at all times.
When transporting the snow plow to avoid engine overheating , angle
the moldboard completely, carrying it as low as permitted for safety by
road and surface conditions.
General Maintenance
Meyer Products recommends this maintenance information for regular
service. Sustained heavy operation may call for more frequent
service. Snow plowing subjects a vehicle to exceptionally rugged use.
As a result, it is important to inspect and bring the snow plow and
vehicle up to maximum operating conditions. Inspection should be
made of both the vehicle and snow plow prior to the plowing
season and after each use.
IMPORTANT: Maintenance and repairs should be performed with
the moldboard on the ground.
Pre-Season Maintenance
Scheduled vehicle maintenance should be performed as
recommended by the manufacturer.
Don't forget that in addition to keeping equipment in order:
1. Keep windshield wipers, heaters and lights working.
2. Use emergency flasher lights for increased visibility and safety.
Meyer offers as standard equipment quartz halogen snow plow
lights for even brighter illumination.
3. Equip vehicles with chains where necessary.
4. Provide operators with protective clothing and with rubber gloves
for handling snow melting chemicals.
VEHICLE ELECTRICAL SYSTEM — For maximum efficiency, the
vehicle supporting the snow plow must be properly serviced. The
system should consist of at least a 70 amp/hr. battery and a 60 amp
alternator. Be sure to check regularly:
1. Battery terminals to assure they're clean and free of corrosion.
2. Electrical connections, to assure they're tight and corrosion-free.
Taping may be called for. All wires must be held clear of moving or
hot engine parts or sharp sheet metal.
3. Battery must be in top operating condition.
4. Alternator and regulator, to assure maximum electrical output.
SNOW PLOW
NOTE: Always lower moldboard to ground when vehicle is not in
use. Check the Electro-Touch® Diagnosis Chart, page 16-17, and
Post Season Maintenance, page 19, for advice on maintaining the
unit.
18