Metz mecablitz 44AF-2 digital, Руководство по эксплуатации

Страница: 118 / 202

+
+
118
(depending on the camera type) on the
camera or by the camera’s master is
possible.
For slave flash unit 44AF-2, slave group
A as well as all remote channels 1, 2, 3
and 4 are always set.
Configuration procedure for remote
slave flash mode
• Switch on the flash unit by pressing
the button .
• Press the “SL” button on the flash
unit to configure the remote slave SL
flash mode. The setting is effective
immediately and saved automatically.
Checking the remote flash mode
• Position the slave flash unit accor-
ding to subsequent shooting require-
ments.
A flash unit stand S60 (accessories)
should be used when setting up the
slave flash unit.
• Wait until all involved flash units are
ready. When flash readiness is achie-
ved for the slave units, the AF measu-
ring beam
will start flashing.
• To release a test flash, press the
manual firing button on the master
or controller flash unit. The slave
flash units will respond with a test
flash. Should a slave not respond,
adjust the position of the slave so
that the slave sensor f can receive
light from the master or controller
flash unit.
8 Modelling light (ML)
Modelling light is only possible if the
function is integrated into the camera.
Modelling light (ML) uses a high fre-
quency strobe light.
It gives the impression of quasi conti-
nuous light for 3 seconds.
Modelling light allows you to evaluate
light distribution and shadow prior to
the shot.
Modelling light is activated via the
camera.
M
TTL LED
SL
k
+