METVISA CFH.300 Series, Инструкция по эксплуатации

Страница: 16 / 28

16
ATTENTION!
Do not use water jet to clean the equipment.
IMPORTANT
This equipment is not intended to be immersed in water for cleaning.
Follow the instructions below to find out which parts can be immersed and the special care
to be taken with the other parts.
The detachable parts (structure, sharpener/deburring and drive disc) must be removed from
the equipment (as instructed in item 4.3) and washed with water and neutral detergent. Clean the
corners well, eliminating food residues.
The rest of the equipment should be cleaned as often as possible to prevent food residues
from drying out and sticking to the parts. For cleaning, dilute the soap or neutral detergent in warm
water and apply with a soft cloth. With a cloth dampened with water, rinse and then dry the parts with
a soft, dry cloth.
If necessary, the vertical and horizontal fasteners can also be removed to clean the
equipment.
Never use abrasive products or sponges and substances containing acids or chlorine to clean
metal parts, as they can scratch or damage the surface of the parts causing corrosion points. Do not
pour water over the motor and electrical parts for cleaning, otherwise, when turning it on, it may cause
an electric shock or even burn the equipment.
After cleaning the mobile table, it is recommended to always check and keep the rails and the
transverse groove lubricated, avoiding their oxidation and contamination of the stainless parts. Keep
lubricating with white Vaseline oil or other non-toxic products found on the market. Never use oil from
oilseeds or olives, as this may compromise the functioning of the mobile table.
ATTENTION!
Take care when cleaning the cutting disc and the vertical fastener, as they are parts that
have extremely sharp blades. Handle with care, otherwise it may cause accidents. The same
attention applies to any other sharp component of the equipment.
As soon as you finish cleaning the cutting disc, replace the movable table.
Never operate the equipment without the mobile table mounted, as this could cause
accidents.
IMPORTANT
The manufacturer does not take responsibility for possible direct or indirect damage caused
by non-compliance with the rules and instructions presented in this manual.