Sys*Stim 294 Instruction Manual—
Rev.F_09/13/17
27
Figure 4.6—Using the Pencil
Electrode
The pencil electrode is used for the stimulation of
small muscles or painful areas. It is also useful to help
identify the exact motor point of a muscle or muscle
group. The pencil electrode may be used with the
“High Volt”, “Microcurrent”, “Premodulated”,
“Medium Frequency” or “Biphasic” waveforms.
Attach the pencil electrode to the black electrode cable
using a pin to banana adapter. Attach the red
electrode cable to a dispersive pad. Apply dispersive
electrode in such a manner to prevent transthoracic
stimulation
Pressing the switch located on the pencil electrode
will allow treatment currents to be delivered to the
patient. Four tips o
f different sizes are included with the pencil electrode.
The figure on the left shows an application of the
pencil electrode.
Please Note:
If you are using the pencil electrode with the microcurrent
waveform, you must press the button on top of the pencil
electrode to establish contact prior to starting a treatment
or a contact error will occur. Once the treatment begins,
hold the button down while increasing output intensity.
7.
Additional information about electrode placement:
Motor point charts are available as guides from
Mettler Electronics Corp. These points may vary from
patient to patient, and at time of injury, may vary in
the same patient. The
Electrical Stimulation &
Ultrasound
Pocket Guide
by Michelle Cameron is
provided at no charge with the Sys*Stim 294.
Содержание Sys*Stim 294
