Sys*Stim 294 Instruction Manual—
Rev.F_09/13/17
13
Section 3—Installation
3.1 Installation Instructions
1.
Connect the line cord to the back of the Sys*Stim 294. (See Figure 3.1)
2.
Plug the line cord (ME 7293) into a grounded wall outlet that is rated between 90–240
VAC, 50–60 Hz. Your power supply must match the voltage requirements listed on the
serial number label of your device.
Do not connect the
Sys*Stim 294
to a power
supply rated differently than that described above.
3.
The line cord comes equipped with a standard 3–prong plug. This plug provides
grounding for the Sys*Stim 294. Do not defeat its purpose by using 3–to–2 prong
adapters or any other means of attaching to a wall outlet.
4.
Plug the electrode cables (ME 2260) into the electrode cable connections as seen in
Figure 3.2.
5.
The Sys*Stim 294 may be susceptible to interference originating from shortwave
diathermy units operating in close proximity to it. Avoid operating the Sys*Stim 294
adjacent to and simultaneously with operating shortwave devices.
6.
Do not use sharp objects to operate the membrane panel switches.
If the tough outer
layer of the membrane is broken, moisture may leak into the switches resulting in
switch failure.
7.
Once you have verified proper functioning of your Sys*Stim 294, using the instructions
in Section 4, please fill in the enclosed self–addressed Warranty Registration Card and
mail it to Mettler Electronics.
Mains Power Switch
Line Cord Connection
Figure 3.1— Sys*Stim 294, Back View—
Mains Power Switch and Line Cord Connection
Содержание Sys*Stim 294
